American Standard 4332.400.002 Instalační příručka stáhnout pdf

Installation

Instructions

M968576

Certiﬁed to comply with ANSI A112.18.1M

CAUTION

INSTALL FITTING (4332.001/.400)

Turn off hot and cold water

supplies before beginning.

Plumbers' Putty or Caulking

Adjustable Wrench

Phillips Screwdriver

Channel Locks

Recommended Tools

Make certain the SEAL (1) is properly seated in recess

of faucet body.

Insert supply HOSES (2) and SHANK (3) through center

hole of sink or mounting surface.

Assemble RUBBER WASHER (4), PLASTIC WASHER (5),

METAL WASHER (6) and threaded LOCKNUT (7) onto

SHANK (3) from underside of sink or mounting surface.

Hand tighten LOCKNUT (7) and check that faucet is centered.

Use a screwdriver to tighten SCREWS (8) on LOCKNUT (7).

Work your way around LOCKNUT (7), tightening the screws

slightly each time until all are snug to ensure even pressure.

Tubing Cutter

RECESS

Thank you for selecting American-Standard...the

benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly-

please read these instructions carefully before

you begin.

4332.001.XXX

4332.400.XXX

PEKOE

SINGLE FUCTION KITCHEN FAUCET

SINGLE FUCTION BAR FAUCET

1 2 3

Shrnutí obsahu

Strany 1 - Instructions

InstallationInstructionsM968576Certiﬁed to comply with ANSI A112.18.1MCAUTION1INSTALL FITTING (4332.001/.400) Turn off hot and cold watersupplies befo

Strany 2 - HOT & COLD SUPPLIES

M968576REDSTRIPEBLUESTRIPE2MAKE WATER SUPPLY CONNECTIONSTurn off hot and cold water supplies before beginning.Connect FLEXIBLE SUPPLIES (1, 2) directl

Strany 3 - 3mm HEX WRENCH

M96857631SERVICE5Loosen and remove LEVER HANDLE (1). LoosenHANDLE SCREW (2) with 2.5mm Hex Wrench andthen pull HANDLE BASE (3) off.Unscrew ESCUTCHEON