American Standard 4662.002.075 Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro Zdravotnický sortiment American Standard 4662.002.075. American Standard 4662.002.075 Installation Guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 7
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
M965107
Installation
Instructions
Certified to comply with ANSI A112.18.1M
1
INSTALL FAUCET
Installation with DECK ESCUTCHEON: Apply a
light bead of plumbers putty to underside of
ESCUTCHEON (1) if mounting surface is uneven.
Place ESCUTCHEON (1) onto sink or mounting
surface. Insert all HOSES (2) and SHANK (3) through
ESCUTCHEON (1) and mounting surface. Figure A.
Assemble RUBBER WASHER (5), BRASS WASHER (6)
and threaded LOCKNUT (7) onto SHANK (3) from
underside of sink or mounting surface. Hand tighten
LOCKNUT (7). Check that rotation of HANDLE (4)
from HOT to COLD is centered. Figure B.
RECOMMENDED TOOLS
Adjustable WrenchRegular Screwdriver Phillips Screwdriver
Turn off water at
main supply.
CAUTION
Channel Locks
1
5
6
7
SINGLE HOLE
FILTER DECK PLATE
FILTER FAUCET
ASSEMBLY
SOAP DISH
F30
FILTER
FILTER
HOUSING
COLLET
*WATER
BOTTLE
OPTIONAL
FILTER CAP
UP
All American Standard Products Are Water Tested At Our Factory.
Some Residual Water May Remain In The Valve During Shipping.
UNPACKING
1. Remove the Filter Faucet items from the carton. The illustration below shows all items after they have been
removed from the carton. Some items may be packaged partially assembled to other items.
FACTORY
INSTALLED
SEAL
PLUMBERS PUTTY
(If required)
4
2
3
4
Figure A.
Figure B.
HOT
COLD
FILTER
H
a
n
d
l
e
t
r
a
v
e
l
i
s
c
e
n
t
e
r
e
d
SINGLE CONTROL
KITCHEN FILTER FAUCET
4662.002
1
MOUNTING KIT
ESCUTCHEON
MOUNTING
SURFACE
UP
Thank you for selecting American-Standard...the benchmark of fine
quality for over 100 years.
To ensure that your installation proceeds smoothly--please read these
instructions carefully before you begin.
The system and installation shall comply with applicable state and local regulations.
*Note: The water bottle has not been evaluated
to the NSF/ANSI 42 and 53 standards.
Zobrazit stránku 0
1 2 3 4 5 6 7

Shrnutí obsahu

Strany 1 - UNPACKING

M965107InstallationInstructionsCertified to comply with ANSI A112.18.1M1INSTALL FAUCETInstallation with DECK ESCUTCHEON: Apply alight bead of plumbers

Strany 2

M965107SECURE FILTER FAUCET TO MOUNTING SURFACE2CONNECT HOT AND COLD WATER SUPPLIES312Use a screwdriver to tighten SCREWS (1) on LOCKNUT (2).Work your

Strany 3 - FILTER HOUSING INSTALLATION

M965107COLLETASSEMBLY(RETRACTEDAGAINSTSTOP)COLLETASSEMBLYREMOVEDPULL DOWN TO REMOVESTOPBUMPBUMPFILTERHOUSINGSEALUPUPUPFILTER HOUSING INSTALLATION4Remo

Strany 4 - FILTER INSTALLATION

M96510754PUSH HOSES UP UNTILFULLY ENGAGEDINTO FILTER HOUSING BLUE AND WHITECONNECTORS(Push in to removeHOSES) BLUEWHITE132ATTACH FILTER LINESPush the

Strany 5 - OPERATION

M965107SPOUTTESTING INSTALLED FAUCET AND FILTER OPERATIONHANDLEOPERATIONHOTOFFCOLDFILTERMove handle into "OFF" position and remove Aerator (

Strany 6 - FIGURE A

M965107Filter Cartridge ReplacementSuggested frequency of filter replacement is every 3 months.Replacement (F30) filters can be purchased online at ww

Strany 7 - SINGLE CONTROL

M962146-0070AMOUNTING RING KITM911261-0070ASPOUT SEALM921540-0070A“U” CONNECTORM965107A954427-0070ACOLLET ASSEMBLY066070-YYY0AAERATORM961772-0070AFILT

Komentáře k této Příručce

Žádné komentáře