American Standard T064.740.295 Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro Zdravotnický sortiment American Standard T064.740.295. American Standard T064.740.295 Installation Guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 3
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
SERIN
T064.740
Installation
Instructions
M968984 REV.1.2
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Certified to comply with ANSI A112.18.1M
ASSE 1016
ROUGHING-IN DIMENSIONS
Recommended Tools
Flat Blade Screwdriver
Phillips Screwdriver
Remove as much surface dirt and film using clear
water and soft cotton cloth
(as described above).
Use any of the following to remove tough surface
film and build-up:
Mild liquid detergents
Clear ammonia free liquid glass cleaners
Non-acidic, non-abrasive gentle liquid or fully
dissolved powder cleansers mixed according to
manufacturers directions.
Non-abrasive liquid polishers
Once clean, rinse faucet again with clear water to
thoroughly remove cleaner or polish and blot dry with
a soft cotton cloth.
To keep your new faucet looking new, please follow
these simple care instructions:
DO: Simply rinse the faucet clean with clear water.
Dry the faucet with a soft cotton cloth.
DO NOT:
Do not use any abrasive cleaners, cloths, or
paper towels.
Do not use any cleaning agents containing
acids, polish abrasives, or harsh cleaners or
soaps.
Regular and routine cleaning will reduce the need for
heavy cleaning and polishing. If heavy cleaning is
required, the following procedures are recommended:
CARE INSTRUCTIONS:
Failure to follow these care instructions may
damage the Faucet's finish.
2-HANDLE THERMOSTAT
WITH VOLUME CONTROL
TRIM KIT
186mm
(7-3/8)
100mm
(3-7/8)
200mm
(7-7/8)
48mm to 68mm
(2 to 2-5/8)
150mm
(6)
NOTE: FITTING
MUST BE INSTALLED
WITH VOLUME CONTROL
ON TOP.
R520
1/2" NPT INLETS
or
R540
3/4" NPT INLETS
25mm
(1)
FINISHED
WALL
160mm
(6-1/4)
Zobrazit stránku 0
1 2 3

Shrnutí obsahu

Strany 1 - Instructions

SERIN™T064.740InstallationInstructionsM968984 REV.1.2Thank you for selecting American-Standard...the benchmarkof fine quality for over 100 years.To ens

Strany 2 - (BLUE TO RED)

TOP M968984 REV.1.21Remove PLASTER GUARD (1) if attached.Push CAPS (2 & 2a) as shown onto CONTROLVALVES (3).Push ESCUTCHEON HOLDER (4) with lightl

Strany 3

M968984 REV.1.2444TEMPERATURE ADJUSTMENTSET HOT LIMIT STOPCheck that arrow marking B points to the 3 o'clock position. If not, push the BLACK CLA

Komentáře k této Příručce

Žádné komentáře