American Standard Jasmine 3821.6XX Uživatelský manuál stáhnout pdf

Installation

Instructions

M968188 REV. 1.1

Certiﬁed to comply with ANSI A112.18.1M

3821.6XX

INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON

SPOUT BASE

Assemble RUBBER WASHER (5), BRASS WASHER (6), and threaded LOCKNUT (7) onto SHANK (4) from underside

of sink or mounting surface. Hand tighten LOCKNUT (7) and check that rotation of HANDLE (8) from HOT to COLD

is centered.

Push O-RING (11) onto SPOUT SHANK (4). Make certain the O-RING (11) is properly seated in recess of DECORATIVE

FLANGE (10).

Insert SUPPLY HOSES (3) and SHANK (4) through mounting hole and seat DECORATIVE FLANGE (10) onto sink or

mounting surface.

Use a screwdriver to tighten SCREWS (9) on LOCKNUT (7). Work your way around LOCKNUT (7), tightening

the screws slightly each time until all are snug to ensure even pressure.

(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON (1). Insert supply

HOSES (3) and SHANK (4) through hole of ESCUTCHEON (1) and mounting surface. Make certain the O-RING (2)

is properly seated in recess of SPOUT BASE. Follow mounting instructions below to secure faucet to mounting surface.

(B) Installation less ESCUTCHEON (1). Remove ESCUTCHEON (1) , feed FAUCET HOSES (3) and SHANK (4) through

DECORATIVE FLANGE (10). Push FLANGE (10) so the raised step ﬁts into recess of SPOUT BASE.

PUTTY

SINK OR

MOUNTING

SURFACE

SINGLE CONTROL KITCHEN

FAUCET AND CAST SPOUT

Thank you for selecting American-Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--

please read these instructions carefully before you begin.

TOOLS REQUIRED

Plumbers' Putty or Caulking

Adjustable WrenchChannel Locks Regular Screwdriver

Phillips ScrewdriverPhillips Screwdriver

Turn off water at

main supply.

CAUTION

1 2 3

Installation 1

Shrnutí obsahu

Strany 1 - Installation

InstallationInstructionsM968188 REV. 1.1Certiﬁed to comply with ANSI A112.18.1M3821.6XX8AB1INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEONSPOUT BASEAss

Strany 2

M968188 REV. 1.1On model with separate spray, place the SPRAY HOLDER (1) into the appropriate mountinghole. Assemble the SPRAY HOLDER WING NUT (2)onto

Strany 3

M968188 REV. 1.15TEST INSTALLED FAUCETMove HANDLE down into "off" position and remove AERATOR.Turn on water supplies and check connections f